A710 Gr.A GMAW 예열 — 3/4" to 1-1/2"

GMAW (Gas Metal Arc Welding)

GMAW (MIG) feeds continuous solid wire with shielding gas — an inherently low-hydrogen process assigned to Category B in Table 5.11.

On high-strength plate, GMAW wire selection must meet the specified minimum tensile to satisfy weld metal matching. ER80S-D2 or ER100S-G wires serve higher-strength steels. The inherently low hydrogen input of solid wire makes GMAW particularly well-suited for crack-sensitive TMCP grades where minimizing diffusible hydrogen is the primary fabrication objective.

A710 Gr.A

ASTM A710 Grade A is a precipitation-hardened low-carbon steel plate achieving high strength through copper precipitation rather than carbon content. Class 2 (65 ksi yield, age-hardened at mill) and Class 3 (75 ksi yield, precipitation-hardened after fabrication) both feature very low carbon (0.07% max) producing a CE-IIW of approximately 0.32-0.38 — among the lowest of any high-strength steel. Table 5.11 assigns Category C for standard low-hydrogen processes and the reduced Category D preheat (32°F all thicknesses) with H8-certified consumables, reflecting the exceptional hydrogen cracking resistance of this ultra-low-carbon metallurgy. The precipitation hardening mechanism means weld thermal cycles can alter the strength in the HAZ depending on peak temperature and cooling rate, requiring attention to heat input control during procedure qualification.

GMAW를 사용한 A710 Gr.A의 이 예열 이유

Precipitation-hardened low-carbon plate with multiple category paths. The higher strength level of this steel places it in Category C of Table 5.11, which carries elevated preheat requirements compared to Category B grades. At 150°F minimum with GMAW, the preheat ensures the cooling rate stays slow enough to prevent hydrogen-induced cracking in this higher-hardenability material. Category C steels demand careful attention to interpass temperature control throughout the weld sequence.

A710 Gr.A의 일반적인 용도

Found in naval hull plates, military vehicle armor brackets, offshore platform node connections, heavy-lift crane boom sections, and mine hoist drum shells. A710 Gr.A precipitation-hardened plate offers a rare combination of high strength and exceptional weldability at low carbon equivalent (CE-IIW approximately 0.32-0.38). The multiple thickness-dependent category paths (B, C, and D with H8) reflect its complex metallurgical response to different section sizes. Class 2 plate is age-hardened at the mill through a controlled thermal cycle, while Class 3 achieves higher strength through precipitation hardening after welding, which makes it particularly suitable for applications where extensive welding occurs before final strengthening. The distinction between Class 2 and Class 3 response to weld thermal cycles requires careful attention during procedure qualification. Plate thicknesses up to 6" are available but procurement requires extended lead times due to limited production volume.

3/4" to 1-1/2"에서 예열이 중요한 이유

Preheat climbs at this range as thicker material slows heat dissipation, trapping hydrogen at crack-susceptible grain boundaries.

3/4" to 1-1/2"에서 GMAW를 사용하는 다른 강재

A710 Gr.A, GMAW

다양한 조합 시도

인터랙티브 예열 계산기를 사용하여 D1.1:2025 표 5.11의 모든 강재, 공정, 두께 조합을 조회하세요.

A710 Gr.A 용접 가이드