A537 Cl.1/2 SMAW (low-hydrogen) 예열 — 1-1/2" to 2-1/2"

SMAW (Low-Hydrogen)

Low-hydrogen SMAW (E7018/E7016) uses basic-coated electrodes requiring rod oven storage, assigned to Category B in Table 5.11.

On pressure vessel plate, E7018 is the standard manual electrode for nozzle welds, manhole reinforcements, and repair welding. ASME Section IX procedure qualifications typically require all-weld-metal tensile and guided bend tests. Rod moisture control is critical in vessel fabrication because vessel codes impose stricter hydrogen limits than structural codes.

A537 Cl.1/2

ASTM A537 Class 1 and Class 2 are heat-treated carbon-manganese-silicon steel plates for pressure vessels. Class 1 is normalized (50 ksi yield, 70-90 ksi tensile up to 2.5"); Class 2 is quenched and tempered for higher strength (60 ksi yield, 80-100 ksi tensile up to 2.5"). Both fall under Category B in Table 5.11, requiring low-hydrogen processes for their improved strength and toughness properties. Carbon content is limited to 0.24% max, but the manganese range (0.70-1.35%) and silicon (0.15-0.50%) contribute to a CE-IIW of approximately 0.40-0.46. A537 Class 2 Q&T plates require careful attention to maximum interpass temperature to avoid re-austenitizing the heat-affected zone and degrading the tempered microstructure achieved during mill heat treatment.

SMAW-LH를 사용한 A537 Cl.1/2의 이 예열 이유

Heat-treated pressure vessel plate with normalized and quenched-tempered options. This steel is prequalified only with low-hydrogen processes under Table 5.11, which is why it appears in Category B but not Category A. The 150°F minimum preheat with SMAW-LH balances the steel's strength level and carbon equivalent against the controlled hydrogen input from the consumable. Non-low-hydrogen SMAW is not an option for this grade under D1.1 prequalified WPS.

A537 Cl.1/2의 일반적인 용도

Applied in cryogenic storage tanks for LNG and liquid nitrogen, elevated-temperature pressure vessels in chemical processing, heavy-wall reactor components, and nuclear containment liner plates. A537 Class 2 quenched-and-tempered plate serves in vessels requiring both high strength and superior impact toughness at sub-zero testing temperatures. Shell course welds and head-to-shell junctions are the primary high-restraint joints where preheat compliance is most critical. Impact testing temperatures for cryogenic service can be as low as -150°F, requiring CVN testing at the design minimum temperature plus a safety margin. The quenched-and-tempered condition of Class 2 means interpass temperature maximums (typically 400-450°F per the qualified WPS) must also be controlled to avoid re-austenitization of the heat-affected zone. Vessel head pressing and spinning from flat plate introduces residual stress concentrations at the knuckle radius that influence the welding sequence for head-to-shell circumferential seams.

1-1/2" to 2-1/2"에서 예열이 중요한 이유

Heavy plate with significant restraint and thermal mass — preheat is critical to maintain slow cooling for hydrogen escape.

1-1/2" to 2-1/2"에서 SMAW (low-hydrogen)를 사용하는 다른 강재

A537 Cl.1/2, SMAW (low-hydrogen)

다양한 조합 시도

인터랙티브 예열 계산기를 사용하여 D1.1:2025 표 5.11의 모든 강재, 공정, 두께 조합을 조회하세요.

A537 Cl.1/2 용접 가이드