A537 Cl.1/2 Preheat for FCAW — 3/4" to 1-1/2"

FCAW (Flux Cored Arc Welding)

FCAW uses tubular flux-cored wire, available gas-shielded (E71T-1) or self-shielded (E71T-8) for field work. Category B in Table 5.11.

For vessel fabrication, FCAW offers a productivity advantage over SMAW on long circumferential and longitudinal seams. Gas-shielded E71T-1 provides consistent bead profile for radiographic quality. Self-shielded wire is generally not approved for ASME pressure service due to higher inclusion content in the weld deposit.

A537 Cl.1/2

ASTM A537 Class 1 and Class 2 are heat-treated carbon-manganese-silicon steel plates for pressure vessels. Class 1 is normalized (50 ksi yield, 70-90 ksi tensile up to 2.5"); Class 2 is quenched and tempered for higher strength (60 ksi yield, 80-100 ksi tensile up to 2.5"). Both fall under Category B in Table 5.11, requiring low-hydrogen processes for their improved strength and toughness properties. Carbon content is limited to 0.24% max, but the manganese range (0.70-1.35%) and silicon (0.15-0.50%) contribute to a CE-IIW of approximately 0.40-0.46. A537 Class 2 Q&T plates require careful attention to maximum interpass temperature to avoid re-austenitizing the heat-affected zone and degrading the tempered microstructure achieved during mill heat treatment.

Why This Preheat for A537 Cl.1/2 with FCAW

Heat-treated pressure vessel plate with normalized and quenched-tempered options. This steel is prequalified only with low-hydrogen processes under Table 5.11, which is why it appears in Category B but not Category A. The 50°F minimum preheat with FCAW balances the steel's strength level and carbon equivalent against the controlled hydrogen input from the consumable. Non-low-hydrogen SMAW is not an option for this grade under D1.1 prequalified WPS.

Typical Applications for A537 Cl.1/2

Applied in cryogenic storage tanks for LNG and liquid nitrogen, elevated-temperature pressure vessels in chemical processing, heavy-wall reactor components, and nuclear containment liner plates. A537 Class 2 quenched-and-tempered plate serves in vessels requiring both high strength and superior impact toughness at sub-zero testing temperatures. Shell course welds and head-to-shell junctions are the primary high-restraint joints where preheat compliance is most critical. Impact testing temperatures for cryogenic service can be as low as -150°F, requiring CVN testing at the design minimum temperature plus a safety margin. The quenched-and-tempered condition of Class 2 means interpass temperature maximums (typically 400-450°F per the qualified WPS) must also be controlled to avoid re-austenitization of the heat-affected zone. Vessel head pressing and spinning from flat plate introduces residual stress concentrations at the knuckle radius that influence the welding sequence for head-to-shell circumferential seams.

Why Preheat Matters at 3/4" to 1-1/2"

Preheat climbs at this range as thicker material slows heat dissipation, trapping hydrogen at crack-susceptible grain boundaries.

Other Steels with FCAW at 3/4" to 1-1/2"

A537 Cl.1/2 with FCAW

Try Different Combinations

Use the interactive preheat calculator to look up any steel, process, and thickness combination from D1.1:2025 Table 5.11.

A537 Cl.1/2 Welding Guides