API 5L X42のSMAW (non-low-hydrogen)用予熱 — up to 3/4"

SMAW (Non-Low-Hydrogen)

Non-low-hydrogen SMAW (E6010/E6011) uses cellulosic electrodes with higher hydrogen potential, assigned to Category A in Table 5.11.

On pipe joints, non-low-hydrogen SMAW root passes with E6010 use the keyhole technique to ensure complete penetration. Pipe rotation (roll welding) is preferred when practical; fixed-position welding requires 5G or 6G qualified procedures. The cellulosic coating generates significant spatter, so adjacent base metal should be protected with anti-spatter compound.

API 5L X42

API 5L X42 is a higher-strength pipeline grade with 42 ksi minimum yield (290 MPa) and 60 ksi minimum tensile, used for moderate-pressure transmission lines operating below 1,000 psi. Despite the strength increase over Grade B, it remains in D1.1 Table 5.11 Categories A and B due to controlled chemistry (PSL 2 limits: 0.22% max carbon, 0.43% max CE-IIW). X42 is common in gas distribution laterals, water transmission mains, and crude gathering systems in pipe sizes from 4" through 36" NPS. The "X" prefix designates minimum yield in ksi — X42 is the lowest X-grade in API 5L, sitting between Grade B and the higher X52/X60/X65 grades used for higher-pressure trunk lines.

API 5L X42とSMAWでこの予熱が必要な理由

Higher-strength pipeline grade at 42 ksi for moderate-pressure transmission. At this thickness, SMAW with non-low-hydrogen electrodes places the joint in Category A of Table 5.11. The minimum preheat of 32°F compensates for the higher diffusible hydrogen from cellulosic electrode coatings. The thicker the material, the longer hydrogen takes to escape the heat-affected zone, which is why preheat rises with thickness even for this common grade.

API 5L X42の代表的な適用例

Deployed in moderate-pressure gas gathering systems, produced water disposal pipelines, crude oil collection networks, and cross-country water transmission trunk lines. X42 mainline girth welds use the same root-fill-cap sequence as Gr.B but with closer attention to bead placement and travel speed on heavier wall pipe to control heat input. Station piping, pig launcher barrel welds, and meter run assemblies are common shop applications. In oilfield gathering systems, X42 pipe diameters typically range from 6" to 20" NPS with wall thicknesses from 0.219" to 0.375". Tie-in welds at valve stations are a common field joint requiring portable preheating equipment. Operating pressures for X42 gathering systems typically run 300-600 psi, governed by ASME B31.8 or DOT 49 CFR 192. Hydrostatic test pressures reach 1.25 to 1.5 times MAOP, putting welds under scrutiny before commissioning.

up to 3/4"で予熱が重要な理由

Thin material sheds heat quickly, allowing hydrogen to escape the HAZ readily — lowest preheat tier in Table 5.11.

SMAW (non-low-hydrogen)とup to 3/4"における他の鋼材

API 5L X42とSMAW (non-low-hydrogen)

別の組み合わせを試す

インタラクティブ予熱計算機を使用して、D1.1:2025 表5.11のあらゆる鋼材・プロセス・板厚の組み合わせを検索できます。

API 5L X42溶接ガイド