A710 Gr.AのSMAW (low-hydrogen)用予熱 — over 2-1/2"

SMAW (Low-Hydrogen)

Low-hydrogen SMAW (E7018/E7016) uses basic-coated electrodes requiring rod oven storage, assigned to Category B in Table 5.11.

For high-strength shapes and plate, E7018 provides adequate tensile match for steels up to Category C. E8018-C3 or E9018-M may be required for higher-strength steels to meet weld metal strength matching requirements. Bead sequencing on thick TMCP flanges should follow qualified WPS parameters precisely to avoid overheating the refined microstructure.

A710 Gr.A

ASTM A710 Grade A is a precipitation-hardened low-carbon steel plate achieving high strength through copper precipitation rather than carbon content. Class 2 (65 ksi yield, age-hardened at mill) and Class 3 (75 ksi yield, precipitation-hardened after fabrication) both feature very low carbon (0.07% max) producing a CE-IIW of approximately 0.32-0.38 — among the lowest of any high-strength steel. Table 5.11 assigns Category C for standard low-hydrogen processes and the reduced Category D preheat (32°F all thicknesses) with H8-certified consumables, reflecting the exceptional hydrogen cracking resistance of this ultra-low-carbon metallurgy. The precipitation hardening mechanism means weld thermal cycles can alter the strength in the HAZ depending on peak temperature and cooling rate, requiring attention to heat input control during procedure qualification.

A710 Gr.AとSMAW-LHでこの予熱が必要な理由

Precipitation-hardened low-carbon plate with multiple category paths. The higher strength level of this steel places it in Category C of Table 5.11, which carries elevated preheat requirements compared to Category B grades. At 300°F minimum with SMAW-LH, the preheat ensures the cooling rate stays slow enough to prevent hydrogen-induced cracking in this higher-hardenability material. Category C steels demand careful attention to interpass temperature control throughout the weld sequence.

A710 Gr.Aの代表的な適用例

Found in naval hull plates, military vehicle armor brackets, offshore platform node connections, heavy-lift crane boom sections, and mine hoist drum shells. A710 Gr.A precipitation-hardened plate offers a rare combination of high strength and exceptional weldability at low carbon equivalent (CE-IIW approximately 0.32-0.38). The multiple thickness-dependent category paths (B, C, and D with H8) reflect its complex metallurgical response to different section sizes. Class 2 plate is age-hardened at the mill through a controlled thermal cycle, while Class 3 achieves higher strength through precipitation hardening after welding, which makes it particularly suitable for applications where extensive welding occurs before final strengthening. The distinction between Class 2 and Class 3 response to weld thermal cycles requires careful attention during procedure qualification. Plate thicknesses up to 6" are available but procurement requires extended lead times due to limited production volume.

over 2-1/2"で予熱が重要な理由

The heaviest sections demand the highest preheat in Table 5.11. Multi-pass sequences require maintaining interpass temperature throughout.

SMAW (low-hydrogen)とover 2-1/2"における他の鋼材

A710 Gr.AとSMAW (low-hydrogen)

別の組み合わせを試す

インタラクティブ予熱計算機を使用して、D1.1:2025 表5.11のあらゆる鋼材・プロセス・板厚の組み合わせを検索できます。

A710 Gr.A溶接ガイド