A53 Gr.BのSMAW (non-low-hydrogen)用予熱 — 1-1/2" to 2-1/2"

SMAW (Non-Low-Hydrogen)

Non-low-hydrogen SMAW (E6010/E6011) uses cellulosic electrodes with higher hydrogen potential, assigned to Category A in Table 5.11.

For common structural shapes and plate, non-low-hydrogen SMAW with E6010 or E6011 excels at root passes on open-root groove welds where burn-through control matters. Vertical-up technique with a slight weave keeps the puddle manageable. Rod consumption runs about 10-12 electrodes per pound of weld metal deposited. Electrode stubs should be no shorter than 2 inches to maintain adequate arc length control.

A53 Gr.B

ASTM A53 Grade B is a standard specification for welded (Type E/ERW and Type S/seamless) steel pipe used in mechanical and pressure applications, with a minimum yield of 35 ksi and 60 ksi minimum tensile strength. It shares chemistry similar to A36 (0.30% max carbon) and falls into the same Table 5.11 categories (A and B). A53 pipe is produced in nominal sizes from 1/8" through 26" NPS in Schedules 10 through XXH. Grade A (lower strength at 30 ksi yield) is also produced but Grade B dominates structural and mechanical service. The ERW weld seam has different properties than the base metal, which affects the heat-affected zone behavior during field welding adjacent to the seam.

A53 Gr.BとSMAWでこの予熱が必要な理由

Welded and seamless pipe for mechanical and pressure service at 35 ksi yield. At this thickness, SMAW with non-low-hydrogen electrodes places the joint in Category A of Table 5.11. The minimum preheat of 225°F compensates for the higher diffusible hydrogen from cellulosic electrode coatings. The thicker the material, the longer hydrogen takes to escape the heat-affected zone, which is why preheat rises with thickness even for this common grade.

A53 Gr.Bの代表的な適用例

Found in pipe columns supporting mezzanines, canopy posts, bollard barriers, sprinkler risers, mechanical chase framing, handrail tubing in industrial plants, and fence line posts. A53 pipe columns in light commercial buildings typically use fillet welds to cap plates and base plates with E70XX electrodes. In parking structures, A53 serves as guard rail posts welded to embed plates. Most A53 pipe comes in Schedule 40 wall thickness (0.237" on 2" NPS, 0.280" on 4" NPS), and typical column sizes range from 4" to 12" nominal pipe size. Joints at base plates often use a 1/4" fillet all-around with a 3/8" tack followed by a continuous pass. Cut ends are squared on a band saw or beveled for butt joints on larger diameters. Field fit-up on pipe columns requires checking plumbness before tacking, as round sections rotate freely and cannot self-align like W-shapes against shear plates.

1-1/2" to 2-1/2"で予熱が重要な理由

Heavy plate with significant restraint and thermal mass — preheat is critical to maintain slow cooling for hydrogen escape.

SMAW (non-low-hydrogen)と1-1/2" to 2-1/2"における他の鋼材

A53 Gr.BとSMAW (non-low-hydrogen)

別の組み合わせを試す

インタラクティブ予熱計算機を使用して、D1.1:2025 表5.11のあらゆる鋼材・プロセス・板厚の組み合わせを検索できます。

A53 Gr.B溶接ガイド